Main Menu

Re-coating Quick-Step timber

The term re-coating refers to lightly sanding the existing coating followed by the application of an additional layer of protective clear coating. Re-coating a floor does not involve sanding the timber, only the existing coating is abraded with a fine sandpaper to prepare for the new coating. SRT, the scratch resistant factory coating applied to Quick-Step timber, has been specifically formulated with the ability to be re-coated using approved solvent based or water based floor coatings. The following steps should be observed when re-coating Quick-Step timber to maximise results.

Use only Approved Coatings

Please check with your local Floorscape office on the best type of coating.

Ensure Abrasion

Prior to application of your new coating, the existing coating needs to be lightly sanded. Use a worn 120 grit or 150 grit abrasive or sandscreen and sand until a uniform film of fine white “sanding powder” is achieved across the floor. Vacuum thoroughly before proceeding to the next step.

Wipe Well

Particularly with older floors, we recommend that the floor be well wiped using premium solvent and a clean, lint-free, white cloth. This process will help to remove any contamination on the floor that may affect the bond of the new coating. It is important to allow the solvent to thoroughly dry prior to the application of the new coating. Two to three hours, weather dependant, should be allowed for the solvent to completely dry. Remember to wipe off any excess solvent left on the floor after wiping using a clean, white, lint-free cloth.

Consider a Professional

The use of an experienced floorsander is an option worth considering when re-coating Quick-Step timber.

Re-coating Quick-Step timber every few years is part of maintaining your timber floor and in doing so will help to ensure that your floor continues to look its’ very best. In many cases, a simple re-coat can restore a tired looking floor to an almost new condition. Not only that but regular re-coating ensures that your floor is protected against day to day wear and tear, a real feature of timber flooring.

Re-sanding Quick-Step timber

Re-sanding refers to the sanding of all existing coating from a timber floor and applying three fresh coats of clear finish. The need for re-sanding arises when part of a floor has worn through to bare timber, usually evidenced by discolouration of the timber in that area. This discolouration occurs as the coating protecting the floor has been worn off and the timber is left exposed to the elements, particularly water or moisture. Quick-Step timber can be re-sanded as many times as a solid, traditional timber floor. In most cases, the re-sanding process calls for large belt sanders, edging machines and large sanding polishers to be used, often requiring a professional floorsander. Quick-Step timber, once re-sanded can be coated with a large variety of approved single pack coatings covering solvent based, oil based and water based products. If you are considering re-sanding your Quick-Step timber yourself, we offer the following recommendations:

Use a Belt not a Drum

Owing to the fact that Quick-Step timber is a floating floor, we recommend the use of a large professional belt floorsander, not a drum sander, to achieve best results.

Only Use Approved Coatings

Please check with your local Floorscape office on the best type of coating.

If you are considering having your floor re-sanded, call your local professional floorsander for advice and pricing information. Information regarding the floorsanders closest to you can be found in the “Find a Retailer” section on our Home Page.